Thursday, February 22, 2018
Setting the Internet using Telkomsel Flash
Setting the Internet using Telkomsel Flash
Telkomsel flash access is a dormitory with up to 3.2 Mbps speeds in the network coverage hspda Telkomsel flash. depending on the device that we use. of course the maximum speed will be obtained when using a device that supports hspda you can see here on the site authorized .
To rate divided three categories, namely :
1. Pay as you go, you will be charged approximately Rp. 350,-/menit
2. Access 3 hours / Rp30.000,- (valid 1 day since the purchase). Access 24 / Rp. 100.000,- (valid for one week since the purchase)
3. Monthly package (only for halo)
Package cost approximately :
40 hours / Rp. 200.000,-
100 hours / Rp. 400.000,-
250 hours / Rp. 800.000,-
Type of card that is used all the product is a product of Telkomsel Sim Card AS, Simpati, Halo)
For a list type flash to tell 3636
Guide to settings you can see below :
no: * 99 *** 1 #
user: (empty)
pass: (empty)
for setting modemnya you add code like this: at + cgdcont = 1, "ip", "flash"
Where do I enter the code as such, is as follows:
1. Click the star
2. Menu Settings
3. Control panel
4. Select the Phone & Modem options Double Click :
* You then select the Modem akan visible Brand modem, if there are some brand modem you select Brand modem that you use what is now Brand.
* Then, you click Properties, then the exit will be a new window: There are General, Modem, Diagnostics, and Advanced Driver. But you click the Advanced menu akan empty boxes out there so you fill in this code at cgdcont + = 1, "ip", "flash" and press ok.
* Then, you click Properties, then the exit will be a new window: There are General, Modem, Diagnostics, and Advanced Driver. But you click the Advanced menu akan empty boxes out there so you fill in this code at cgdcont + = 1, "ip", "flash" and press ok.
if the settings are correct then when you are connected to the first entry should Telkomsel
reference:
reference:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.